PA6T Arlen E335/ E430N/ E630N/ E440NK Mitsui polyamide 6T Resins

In stock

Mitsui PA6T Arlen E335 Mitsui PA6T Arlen E430N

Category:

Mitsui PA6T Arlen E335 Mitsui PA6T Arlen E430N
Mitsui PA6T Arlen E630NMitsui PA6T Arlen E440NK

Package: 25kgs/bagColor: Natural/Black

Introduction:ARLEN™ is a heat resistant, modified polyamide 6T developed by Mitsui Chemicals, Inc. With a high melting point (320°C) and a rigidity level comparable to super engineering plastics, it possesses strong dimensional stability and chemical resistance. In addition, the effect of water absorption, which is a traditional weakness of polyamides, has been reduced to a minimum.
There are three individual offerings in the modified polyamide product series; each polyamide designed to meet a specific application requirement as presented below:

A/G Series: Mechanical and structural parts;AE Series: For tribological applications;C Series: Electrical and electronic parts
Processing Methods:Mitsui Chemicals recommends the following to mold this sophisticated engineering plastic for any application part:

Molding machine:
* The injection molding of this modified polyamide requires a molding machine having wear resistance (corrosion resistance for the flame-retardant grade).
* A small molding machine should be selected so that the volume of one shot will be not less than 10% of the maximum injection capacity.
* A standard nozzle should be used.

Mold:
* A steel material having wear resistance (corrosion resistance for the flame-retardant grade) is required for the construction material of a mold for ARLEN.
* An approximately 10-µ m vent is required.

Predrying:
* Any ARLEN resin that absorbs moisture after the bag is opened needs to be dried again.
* Dehumidifying dryer: 110°C x 2 to 6 hr.

Electronic and Electric Standard Molding Conditions
Mechanical and Structural Standard Molding Conditions

E430N E335





error: Content is protected !!

Main Menu

E430N E335

PA6T Arlen E335/ E430N/ E630N/ E440NK Mitsui polyamide 6T Resins